Expedite Cargo Van Driving Jobs. Feb 21, 2013 Re: raspberry using GPIO with 12V lines Tue Feb 19, 2013 12:30 pm michaell wrote:The +12V in the picture should actually be B+, cars battery voltage taken from some control modules constant +12V.

Yes, you can use Ibus. Crack Phpmaker on this page. Hook up the pins ground, vcc, and CH3/ RXD, to your IO2 connector, and the other end to your receiver.

That is 3 pins on your Io2 connector. I'm using an FS-IAB6 receiver, and it works perfectly.

IO_2 connector - Serial RX / PWM RX / GPIO / UART3 When using a PWM receiver connect CH3/4/7/8 to PWM RX. When using a 3.3v Serial RX receiver (S.Bus, SUMD/H, etc.) use GND/VCC/CH3 (UART3 RX).

CH3/4/7/8 can be used as general purpose IO when not used for Serial/PWM RX. CH7/8 can be used for a 3.3v Sonar sensor when not used for PWM RX.

ADC_1/2 can be used to connect Battery Current Monitoring and RSSI signals.